Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving West Gulfport, MS

Hörmann Garage Door Sensor Repair in West Gulfport, MS

Photo-eye sensors realigned, rewired or replaced so the door closes reliably. Typical cost $100-$250.

Our Hörmann garage door sensor repair service in West Gulfport, MS comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Photo-eye sensors realigned, rewired or replaced so the door closes reliably. Whether your Hörmann opener is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing.

When to call for Hörmann garage door sensor repair

  • The door goes back up right after it starts closing
  • Sensor lights are blinking or off
  • The door only closes when you hold the wall button
  • The opener light flashes when you try to close

Why this happens

  • Sensors bumped out of alignment
  • Dirty lenses or direct sunlight
  • Damaged or loose wiring
  • Failed sensors

What you can check yourself

  • Wipe both lenses with a soft cloth.
  • Adjust the brackets until both indicator lights are steady.
  • Look for staples or damage on the thin sensor wires.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Hörmann garage door sensor repair

  1. Test the sensor voltage and wiring
  2. Realign or replace the sensors
  3. Repair or replace the wiring
  4. Shade sensors from direct sun if needed
  5. Test the auto-reverse

Typical Hörmann garage door sensor repair prices

$100-$250Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Hörmann services

Serving West Gulfport, MS and nearby towns

A closed garage in a Mississippi summer gets very hot, which shortens the life of opener circuit boards, capacitors and photo-eye sensors. Storms add power surges, so a surge protector is cheap insurance.

Our Hörmann garage door sensor repair service covers West Gulfport (ZIP codes 39501, 39502 and 39505) and nearby towns including Gulfport (2.5 mi), Long Beach (5.1 mi), Pass Christian (11 mi) and D'Iberville (12.2 mi). Call (833) 435-8883 to book a visit in West Gulfport.

Hörmann Garage Door Sensor Repair: frequently asked questions

How much does Hörmann garage door sensor repair cost in West Gulfport, MS?

Hörmann Garage Door Sensor Repair typically costs $100-$250 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Hörmann garage door sensor repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Hörmann garage door sensor repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Hörmann warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Mississippi or West Gulfport requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in West Gulfport, MS

Garaga Torsion Spring Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $200-$450

Richards-Wilcox Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Ryobi Garage Door Opener Repair

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $125-$350

Wayne Dalton Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$450

Raynor Garage Door Opener Repair

Openers that hum, click, reverse or won't respond, diagnosed and repaired.

Typical $125-$350

CHI Overhead Doors Garage Door Cable Repair

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $150-$350

Northwest Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Wayne Dalton Weather Seal Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $100-$300

Clopay Garage Door Roller Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$350

Clopay Extension Spring Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$350

Amarr Garage Door Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$450

CHI Overhead Doors Torsion Spring Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $200-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in West Gulfport, MS now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote